双缸式气动-手动楔式闸阀在柴油罐上的应用

文章简单介绍了气动阀的结构、工作原理及特点,并时堆修保养注意事项以及可能发生的故障和排除故障的方法做了详细讲解。最后,将气动阀在柴油罐上的应用情况与普通闸阀相比较,分析其使用性能和优点,进一步推广气动闽在锦西石化分公司的应用。     

On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

改性蜂窝陶瓷催化臭氧氧化净水效能中试研究

通过中试考察了改性蜂窝陶瓷催化臭氧氧化(催化氧化)—活性炭过滤的净水效果,并与臭氧—活性炭工艺进行比较。试验条件下蜂窝陶瓷催化剂在静态和动态条件下均不会促进气体向水中的传质;静态条件下催化氧化对水中有机物的去除效率比臭氧单独氧化高;动态试验中,催化氧化对UV254的去除率高于臭氧氧化,但对TOC的去除没有优势,与臭氧氧化相比催化氧化有利于后续活性炭对有机物的去除。GC/MS测定表明,催化氧化及其后续活性炭出水中半挥发性有机物种类分别比臭氧单独氧化少9%和32%。经Ames试验发现,两种氧化及其后续活性炭处理后水的致突变活性均有微小增加。     

Improving narrow bandgap a-SiGe:H alloys grown by hot-wire chemical vapor deposition

We have improved the electronic properties of narrow-bandgap (Tauc gap below 1.5 eV) amorphous-silicon germanium alloys (a-SiGe:H) grown by hot-wire chemical vapor deposition (HWCVD) by lowering the substrate temperature and deposition rate. Prior to this work, we were unable to grow a-SiGe:H alloys with bandgaps below 1.5 eV that had photo-to-dark conductivity ratios comparable with our plasma-enhanced CVD (PECVD) grown materials [B.P. Nelson et al., Mater. Res. Soc. Symp. 507 (1998) 447]. Decreasing the filament diameter from our standard configuration of 0.5 mm to 0.38 or 0.25 mm provides first big improvements in the photoresponse of these alloys. Lowering the substrate temperature from our previous optimal temperatures (T_sub starting at 435 °C) to at 250 °C provides additional photo-to-dark conductivity ratio increasing by two orders of magnitude for growth conditions containing 20–30% GeH₄ in the gas phase (relative to the total GeH₄+SiH₄ flow).     

Predicting Forest Age Classes from High Spatial Resolution Remotely Sensed Imagery Using Voronoi Polygon Aggregation

Efficient identification of forest age is useful for forest management and ecological applications. Here we propose a user-assisted method for determining forest age using high spatial resolution remotely sensed imagery. This method requires individual trees to be extracted from imagery and represented as points. We use a local maximum filter to generate points that are converted to Voronoi polygons. Properties of the Voronoi polygons are correlated with forest age and used to aggregate points (trees) into areas (stands) based on three forest age classes. Accuracy of the aggregation ranges from approximately 68% to 78% and identification of the mature class is more consistent and accurate than the younger classes.     

基于IP Core的Viterbi高速译码器测试

深入研究了基于Altera的Viterbi v4.3.0 IP核实现高速维特比译码器的测试方法,详细分析了译码器的Atlantic接口信号,给出了采用Paralle1结构Viterbi译码器的仿真结果.研究结果表明应用Viterbi v4.3.0能够设计出符合不同性能要求的高性能维特比译码器,采用面向数据包传输的Atlantic接口使Viterbi译码器具有很高的吞吐量.     

High dynamic range InP HBT delta-sigma analog-to-digital converters

To date, the development of multifunction multicarrier digital receivers for cellular base station and military communications applications has been limited by the demanding dynamic range requirements for the analog-to-digital converter (ADC). The use of oversampling delta-sigma modulators provides a promising approach to overcoming the dynamic range barriers Nyquist-rate converters face in the same applications. This paper discusses issues involved in the design of high-speed high dynamic range wide-band delta-sigma ADCs for such communications applications. Test results of prototype designs are also presented. The delta-sigma modulators described in this paper operate at sampling frequencies ranging from 1 to 2.5 GHz with center frequencies ranging from dc to 100 MHz, providing between 74 and 84.2 dB signal-to-noise ratio (12 and 13.7 bits) for bandwidths of 25 and 12.5 MHz, respectively. The loop filters are continuous-time low-pass and bandpass implementations of order 6 and 10, and were fabricated in an InP heterojunction bipolar (HBT) technology. A typical tenth-order design consumes 6 W of power and occupies a die area of 23.5 mm/sup 2/.     

Improved RNS FIR filter architectures

A new architecture for implementing finite-impulse response (FIR) filters using the residue number system (RNS) is detailed. The design is based on using a restricted modulus set, with moduli of the form 2/sup n/,2/sup n/-1, and 2/sup n/+1. This does not restrict the modulus set to the common 3 modulus set {2/sup n/-1,2/sup n/,2/sup n/+1}, but any number of pairwise relatively prime moduli of this form, for example, {5,7,17,31,32,33}. Based on a comparison with a 2's complement design, the new RNS design can offer a significant speed improvement. The gain is obtained by using a set of small moduli, selected so as to minimize critical path delay and area. An algorithmic approach is used to obtain full adder based architectures that are optimized for area and delay. The modulus set is optimum based on cost parameters for each modulus. This new architecture presents a practical approach to implementing a fast RNS FIR filter.     

以太网供电技术的发展

面向以太网供电（PoE）的IEEE802．3af标准将以太网网络连接引向了一个全新的方向，即以10／100／1000Mbps数据速率一并输送DC功率。伴随PoE而出现的一组独特的问题和崭新的思维方式是许多拥有以太网设备设计经验的工程师过去所并不熟悉的。目前，PoE一般用于VoIP电话、无线接入点和安全摄像机。而随着PoE技术的进步，改进标准的呼声渐起，旨在造就新兴的应用。     

催化裂化汽油固体碱脱硫-固定床脱臭组合工艺的开发

在对活性剂、活化剂等对固体碱脱除硫化氢性能影响研究的基础上,对催化裂化汽油固体碱脱硫-固定床脱臭组合工艺进行了实验室小试,结果表明,固体碱完全可以取代液体碱而用于催化裂化汽油的精制.相对于液体碱洗-固定床脱臭工艺,无论再生前还是再生后,固体碱脱硫-固定床脱臭组合工艺使装置运转时间延长一倍以上.介绍了该组合工艺的流程设计和工业应用.